RP1 Parity
Even
This window shows the RP1 Parity setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
RP1 Timesync
Enable
This window shows the RP1 Timesync setting done previously.
Press the Plus / Up arrow key (+ /) to move to the next option. ***
RP1 Address
001
The window displays the first setting of the Communication menu.
Press the Left arrow key () or Right arrow key () to return to Main
Menu.
COMMUNICATION
Note:
*** By using the Left arrow key (
) or Right arrow key (
) the relay will return to Main Menu.
2.3.10 GROUP 1 MENU
2.3.10.1 Edit settings
GROUP
Password protected window for “GROUP 1” settings i.e. System
Configuration Over Current, Earth Fault, Thermal Overload, Cold Load
Pickup and Under Current Protection.
Press the Left arrow key () to move to the next option.
Password = 0000
Press the Edit Key, the number will start blinking.
Enter the previously set password by using the Plus / Up arrow key (+
/) or the Minus / Right arrow key (- /). The Password setting range
is 0000 to 9999. The Default Password is “0000”
After editing the Password press the Edit Key, the number will stop
blinking.
Press the Left arrow key () to move to the next option.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the Protection Function setting menu can be scrolled and will be
displayed as follows respectively.
To Next Page
Loading...
