IN>1Current Set
0.20 A
The window displays the first setting of the Earth Fault setting menu.
Press the Left arrow key () to move to the next option.
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes and this window will flash for moment. The control will return to
the Main Menu.
GROUP 1
Note:
#. If the function is set as enable then the relay will allow editing the settings of respective sub menus. If the
function is set as disable then the relay will not allow editing the settings of sub menus and will bypass the
protection function.
* The User can scroll the previous settings by using the plus / Up arrow key (+ /
).
** After Editing any sub menus of the Earth Fault setting, If the SET/ Left (
) arrow key is pressed, the Relay
ask SET to SAVE the changes or RESET to CANCEL the changes.
2.3.13.3 Edit settings (if IN>1 function is selected for IEEE Curves)
Earth Fault
By using the Plus / Up arrow key (+ /) or Minus / Right arrow key (-
/) select the Earth Fault setting menu in Group 1.
Press the Left arrow key () to move to the next option.
IN>1Function
US ST Inverse
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired IN>1 Function (Curve Selection) can set i.e. Disable /
US ST Inverse / US Inverse / IEEE E Inverse / IEEE V Inverse / IEEE M
Inverse / UK LT Inverse / IEC E Inverse / IEC V Inverse / S Inverse (1.3
Sec) / IEC S Inverse and DT. #
After selecting the desired IN>1 Function press the Edit Key, the text will
stop blinking.
Press the Left arrow key () to move to the next option.
To Next Page
Loading...
