Alstom MiCOM P50 Agile P15D - Page 96

5 Configuration
P50 Agile P15D
5-60
P15D/EN TM/B
2.3.17 GROUP 2 MENU
2.3.17.1 Edit settings
GROUP 2
Password protected window for “GROUP 2” settings i.e. System
Configuration, Over Current, Earth Fault, Thermal Overload, Cold Load
Pickup and Under Current Protection.
Press the Left arrow key () the relay will display as follows.
Password = 0000
Press the Edit Key, the number will start blinking.
Enter the previously set password by using the Plus / Up arrow key (+
/) or the Minus / Right arrow key (- /). The Password setting range
is 0000 to 9999. The Default Password is “0000”
After editing the Password press the Edit Key, the settable number will
stop blinking.
Press the Left arrow key () to move to the next option.
By using the Plus / Up arrow key (+ /) or Minus / Right arrow key (-
/) the Protection Function setting menu can be scrolled and will be
displayed as follows respectively
SYSTEM CONFIG
Password protected window for “SYSTEM CONFIGURATION” settings
OVERCURRENT
Password protected window for “OVERCURRENT” Protection settings
EARTH FAULT
Password protected window for “EARTH FAULT” Protection settings
THERMAL OVER LOAD
Password protected window for “THERMAL OVERLOAD” Protection
settings
COLD LOAD PICKUP
Password protected window for “COLD LOAD PICKUP” Protection
settings