Need help?Do you have a question about the Altec Lansing 288-16K HF DRIVER and is the answer not in the manual?
General| Brand | Altec Lansing |
|---|---|
| Model | 288-16K HF DRIVER |
| Category | Speakers |
| Language | English |
Details Altec 288 drivers' use in theatres and smooth response from 500-15,000 Hz.
Low wattage requirement due to low diaphragm/voice coil mass and larger magnet structure.
Field-replaceable diaphragm/voice coil assembly with 20,500 gauss flux density.
Rated at 15 watts continuous pink noise, band-limited from 500-20,000 Hz.
Provides a uniform frequency response from 500 to 15,000 Hz.
Measures 109 dB SPL at 4' with 1 watt input, band-limited from 500-3000 Hz.
Available in 8, 16, and 32 ohm impedance versions.
Features a 6.87-pound Ferrite V magnet with 20,500 gauss flux density.
Aluminum diaphragm with tangential suspension and 2.8" edge-wound aluminum ribbon voice coil.
Measures 7.61" diameter by 5.8" deep, weighing 30.5 pounds.
Mounts via three 3/8"-24 x 1" studs, 120° apart on 3.25" centers.
Specifies requirements for power capacity, frequency response, and pressure sensitivity.
Details voice coil diameter, material, and magnetic gap flux density.
Covers diaphragm material, suspension, driver dimensions, and weight.
Identifies specific models based on impedance (288-8K, 288-16K, 288-32K).
To Next Page