Need help?Do you have a question about the Altec Lansing 9444B POWER AMPLIFIER and is the answer not in the manual?
Highlights 16 output transistors, patented protection, superior cooling, and UL/CSA ratings.
Details power output, bridge mode, cooling, and independent channel/load protections.
Details continuous, subwoofer, and midband output power, headroom, and frequency response.
Covers input level, impedance, polarity, phase response, THD, IMD, TIM, and rise/slew rates.
Lists amplifier/load protections, damping factor, crosstalk, noise, cooling, and heatsink specs.
Covers output topology, devices, controls, indicators, connections, power, and operating ranges.
Details heat production, physical dimensions, weight, color, and enclosure materials.
Lists standard, optional accessories, and design/performance approvals like UL and CSA.
Presents graphs for output level and phase response versus frequency.
Shows headroom measurements and A-weighted noise levels against frequency.
Displays THD+N vs. frequency and power, plus SMPTE distortion vs. power.
Shows crosstalk and CMRR (Common Mode Rejection Ratio) versus frequency.
Outlines solid-state design, complementary symmetry, protection features, and rear/front panel features.
Details output power, sensitivity, gain, noise, frequency response, distortion, and damping factor.
Specifies dimensions, weight, temperature range, finish, enclosure, and model identification.
Highlights 16 output transistors, patented protection, superior cooling, and UL/CSA ratings.
Details power output, bridge mode, cooling, and independent channel/load protections.
Details continuous, subwoofer, and midband output power, headroom, and frequency response.
Covers input level, impedance, polarity, phase response, THD, IMD, TIM, and rise/slew rates.
Lists amplifier/load protections, damping factor, crosstalk, noise, cooling, and heatsink specs.
Covers output topology, devices, controls, indicators, connections, power, and operating ranges.
Details heat production, physical dimensions, weight, color, and enclosure materials.
Lists standard, optional accessories, and design/performance approvals like UL and CSA.
Presents graphs for output level and phase response versus frequency.
Shows headroom measurements and A-weighted noise levels against frequency.
Displays THD+N vs. frequency and power, plus SMPTE distortion vs. power.
Shows crosstalk and CMRR (Common Mode Rejection Ratio) versus frequency.
Outlines solid-state design, complementary symmetry, protection features, and rear/front panel features.
Details output power, sensitivity, gain, noise, frequency response, distortion, and damping factor.
Specifies dimensions, weight, temperature range, finish, enclosure, and model identification.
General| Input Impedance | 20 k ohms |
|---|---|
| Damping Factor | Greater than 200 |
| Power Output | 200 watts per channel into 8 ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | Less than 0.1% at rated power |
| Input Sensitivity | 1.0 V for rated power |
| Signal to Noise Ratio | Greater than 100 dB, A-weighted |
| Dimensions | 19" x 5.25" x 15" (W x H x D) |
To Next Page