Altec Lansing M202 - Troubleshooting; Sound is distorted; Full-featured remote doesnt work; No sound from the AUX device, such as an MP3 player or CD player connected to the AUX jack

15
EN
Symptom Possible Problem Solution
Sound is distorted
Volume level is set too high. Decrease the volume.
Sound source is distorted. If the iPhone or iPod original sound source (sound file) is of poor quality,
distortion and noise are easily noticed with high-power speakers. Try a
different audio source such as a music CD.
Full-featured
remote
doesn’twork
Battery is weak. Replace current battery with a new battery.
Full-featured remote is not pointed toward the
speaker system.
Point the full-featured remote toward the Altec Lansing speaker system and
move within 10 feet of the unit.
No sound from
the AUX device,
such as an MP3
player or CD
player connected
to the AUX jack
Volume on the device is set too low. Increase the volume on the device to approximately ¾ full volume.
Source selector is not set to AUX. Set source selector to AUX.
The speaker
system exhibits
erratic or
unexpected
behavior; controls
do not function
Static electricity, momentary interruption of power or
abnormal operating conditions may be responsible.
1. Disconnect the AC adapter cable plug from the speaker system’s jack.
2. Wait 20–30 seconds.
3. Reconnect the AC adapter cable plug to the speaker system’s jack.
Troubleshooting