LIGHTING CONTROL
The Altec Lansing SHOCKWAVE family has four members that support party-sync.
You can mix and match between any of these four models, setting up one
speaker as the primary unit connected to up to 100 other speakers all playing
in sync.
1. Connect one speaker to your Bluetooth device in the normal way via Bluetooth.
2. Double-press the BT button on the next speaker to enter Party-sync mode,
its BT LED will ashes slowly and it will nd and connect to the rst (primary)
speaker.
3. Repeat No 2 if you have more speakers you want to connect.
4. To exit party-sync double press the BT button on the speakers you wish
to disconnect and return to normal operation.
Notes:
Playback volume is adjusted via the rst (primary) speaker.
The BT playback controls only operate on the rst (primary) speaker.
Turning o the rst (primary) speaker turns o all speakers.
All secondary speakers can be turned on/o individually and their light modes
changed via their individual controls.
Briey press the LIGHTS button to switch lighting mode.
(Note: Some modes which use ‘sound-to-light’ need music playing to be visible)
Mode 1:
Rotating ring in three colors
Mode 2:
Flashing to music
Mode 3:
‘Spectrum’
Mode 4:
‘Stacking/re-stacking’ lights both sides
Mode 5:
Rotating lights in multi-colors
Mode 6:
Breathing on/o
Mode 7:
Flashing to music, solid lighting when no audio
Mode 8:
‘Bar-graph’ in multi-colors
Mode 9:
Rotating ‘stacking/re-stacking’ lights
Each press moves to the next mode and back round to o.
To Next Page
Loading...
Need help?
General
