To Next Page
L
Larry SteinAug 16, 2025
What to do if Alto-Shaam Oven is under temperature?
- AAshley EllisonAug 16, 2025
If your Alto-Shaam oven is not reaching the correct temperature, troubleshoot the heating element.
What to do if Alto-Shaam Oven is under temperature?
If your Alto-Shaam oven is not reaching the correct temperature, troubleshoot the heating element.
Why Alto-Shaam Oven shows high limit error?
A high limit error in your Alto-Shaam oven can occur due to several reasons: * Improperly installed jet plate(s). * The cavity fan is not working. * Optional grease filters are blocked with debris. * Heat relay(s) are stuck closed. * Faulty connection between the high limit switch and the control board. * A defective high limit switch.
What causes gas lockout in Alto-Shaam Oven?
A gas lockout in your Alto-Shaam oven is caused by a lack of fuel pressure.
Why Alto-Shaam Oven has bi-metal thermostat open?
An open bi-metal thermostat in your Alto-Shaam oven can be caused by: * Blocked or dirty cooling fan filters. * A cooling fan that is not operating. * A faulty connection between the bi-metal switch and the control board. * Installation without adequate clearance. * A defective bi-metal switch.
What causes gas combustion blower speed failure in Alto-Shaam Oven?
A gas combustion blower speed failure in your Alto-Shaam oven can occur if: * The power supply cable is not connected to the blower motor. * The speed control cable is not connected to the blower motor. * The blower motor is blocked, rotation is impeded, or the motor is faulty. * There is a faulty PWM daughter board.
What causes ignition module/valve failure in Alto-Shaam Oven?
Ignition module or valve failure in your Alto-Shaam oven happens when the valve status is not open after a call for heat.
What causes interface board - control board communication error in Alto-Shaam Oven?
An interface board to control board communication error in your Alto-Shaam oven can be caused by: * A connection issue with the modbus cable. * A faulty modbus cable. * A defective control board. * A malfunctioning interface board.
What causes sensor short in Alto-Shaam Oven?
A sensor short in your Alto-Shaam oven can be caused by: * A problem with the sensor connection. * A defective sensor. * A malfunctioning control board.
What causes sensor open in Alto-Shaam Oven?
A sensor open issue in your Alto-Shaam oven can be due to: * A problem with the sensor connection. * A defective sensor. * A malfunctioning control board.
What to do if the fan indicator light illuminates on my Alto-Shaam Oven?
If the fan indicator light remains on, disconnect the appliance from the power supply and have the Alto-Shaam oven serviced by a qualified technician.
General| Model | VMC-H2 |
|---|---|
| Category | Oven |
| Type | Multi-Cook Oven |
| Configuration | Countertop |
| Number of Chambers | 2 |
| Power Supply | Electric |
| Exterior Material | Stainless Steel |
| Interior Material | Stainless Steel |
| Phase | 3-Phase |
| Cooking Modes | Steam, Convection, Combination |
| Control Type | Touchscreen |
