INSTALLATION
Vecto r H® S eries ▪ Operat or’s M anual ▪ M N-46 2 95 ▪ Rev 7 ▪ 6/22
37
Continued from previous page
8. Install the ground wire f.
Leave an extra loop g so that current-carrying conductors become taut
before the ground wire if the cord is accidentally pulled. Follow applicable
regulations.
Tighten the cord grip sealing nut onto the supply cord.
9. Re-install the main disconnect switch.
10. Re-install the mounting bracket.
11. Re-install the top cover.
Continued on next page
NOTE: The equipotential-bonding terminal is located at
the bottom rear of the oven.
To Next Page
Loading...
