Need help?Do you have a question about the Alto AS-H40Y and is the answer not in the manual?
Details on installing and wiring the optional flow switch for safety.
Details on installing anti-vibration pads and the drain tube for the heat pump.
Specifies the required voltage and frequency ranges for the heat pump operation.
Describes the control panel buttons, display, and initial operation.
Explains temperature differential, defrost cycle, and defrost time settings.
Details operation modes, defrost temperature, economy/standard settings, and back-up heater control.
Explains error codes E1-E4 displayed on the control panel for troubleshooting.
Describes the automatic restart feature after a power interruption.
Explains the automatic defrosting process for the evaporator fins.
Notes on heat pump operation during filter backwashing or waste cycles.
Addresses common user queries regarding operation, installation, and maintenance.
Step-by-step guide for winterising and starting up the heat pump unit.
Outlines the warranty periods for parts and labour for the heat pump.
Lists conditions and damages not covered by the heat pump warranty.
Specifies the requirements for the warranty to be valid, including authorised service.
Clarifies Paramount Pools' liability for incidental and consequential damages.
Covers governing law, jurisdiction, and other legal aspects of the warranty.
Provides guidance on diagnosing and reporting heat pump faults to a service agent.
Lists checks to perform before contacting the service agent to prevent unnecessary calls.
Provides conversion factors for units like BTU, kW, Horsepower, and temperature.
To Next Page
General