11
(4.1) USB Recording and Playback
To set TrueMix 500 as the default playback device on your computer, follow the set
of directions below that corresponds to your computer’s operating system.
Note: If you have other USB audio devices connected to your computer, which may
have identical names, you may need to try selecting each one until the TrueMix 500
is recognized.
Windows 10:
1. Use the included USB cable to connect the TrueMix
500 to your computer. Press the power switch to
power on TrueMix 500.
2. Press the Windows key and then type “Sound
Settings” into the search bar. Alternatively,
right-click the “speaker” icon in the taskbar and
select Open Sound Settings.
3. In the Windows Sound control panel select the
Output dropdown box and select USB Audio
Codec.
4. Select the Input dropdown box and select USB
Audio Codec.
5. Close the Sound control panel.
Windows 11:
1. Use the included USB cable to connect the
TrueMix 500 to your computer. Press the power
switch to power on TrueMix 500.
2. Press the Windows key and then type “Sound
Settings” into the search bar. Alternatively,
right-click the “speaker” icon in the taskbar and
select Sound Settings.
3. In the Windows Sound control panel select the
Output section and select USB Audio Codec.
4. In the Input section select USB Audio Codec.
5. Close the Sound control panel.
macOS:
1. Use the included USB cable to connect the TrueMix 500 to your computer. Press
the power switch to power on TrueMix 500.
2. Go to Applications > Utilities > Audio MIDI Setup.
3. In the Audio Devices window, select USB Audio Codec in the left column.
4. Right-click USB Audio Codec and select Use this device for sound input.
5. Right-click USB Audio Codec and select Use this device for sound output.
6. Quit Audio MIDI Setup.
(4.0) OPERATION
To Next Page
Loading...
Need help?
General