Dishwasher / User’s Manual
11 / 41
EN
Installation
liable for any damages that will arise when 
the product is used without grounding in 
accordance with the local regulations.
 • Connection must comply with national 
regulations.
 • Power cable plug must be within easy 
reach after installation.
B
Unplug the product after the 
washing programme is over.
 • The voltage and allowed fuse or breaker 
protection are specified in the “Technical 
specifications” section. If the current 
value of the fuse or breaker in the house 
is less than 16 Amps, have a qualified 
electrician install a 16 Amp fuse.
 • The specified voltage must be equal to 
your mains voltage.
 • Do not make connections via extension 
cables or multi-plugs.
B
Damaged power cables must 
be replaced by the Authorised 
Service Agent.
B
If your dishwasher is equipped 
with internal illumination, lamp 
should only be replaced by the 
Authorised Service Agent in 
case of failures that may occur 
on the lamp.
B
If the product has a failure, it 
should not be operated unless 
it is repaired by the Authorised 
Service Agent! There is the risk 
of electric shock!
Intal use
Before starting to use the product, make sure 
that all preparations are made in accordance 
with the instructions in sections “Important 
safety instructions” and “Installation”.
 • To prepare the product to do the dishes, 
Aquasafe+ 
(depends on model)
The Aquasafe+ system protects against 
water leaks that may occur at the hose 
inlet.Water contact with the valve box of 
the system must be avoided to prevent 
damage to the electrical system. If the 
Aquasafe+ system is damaged, unplug the 
product and call the Authorised Service 
Agent. 
A
As the hose set contains 
electrical connections and 
assemblies, never shorten 
or lengthen the hose with 
extension hoses.
the feet of the product. Adjust the feet of 
the product as illustrated in the installation 
manual supplied with the product.
A
Dishwashers door must be 
aligned properly otherwise hot 
steam can escape! Danger of 
serious burns, other injury or 
may damage furniture.
Electrcal connecton
Connect the product to a grounded outlet 
protected by a fuse complying with the 
values in the “Technical specifications” 
table. The manufacturer shall not be