Before proceeding to
use the heater, make
sure you understand
the “IMPORTANT
SAFETY
INFORMATION”
section of this manual.
When using your
heater there may be a
slight humming noise,
this is normal.
Fig.C Fig.D
Fig.E Fig.F
7
Connect the plug to the wall
socket, when wall socket is
switched on the red indicator
light on the heater will illumi-
nate. (Figure C)
Press Power button
once again, the digital screen
shows
P. 1 for low heat
setting. (Figure E)
Press Power button
once the digital screen
shows
P. 0, standby
mode. (Figure D)
Press Power button
once again, the digital
screen shows
P.2 for
medium heat setting.
(Figure F)
• Place heater on level ground so it is stable & cannot
fall over
• Adjust the height of your heater by loosening the adjuster
collar, slide top tube to desired height & lock the adjuster
collar by turning clockwise
• Adjust the angle of the heater head by loosening the
plastic bolt & nut slightly and angling head through preset
adjustments. Tighten plastic bolt & nut to lock in position.
• For safety, place the power cable into the two plastic
clips on the stand pole.
USING THE HEATER
1.
3. 4.
2.
To Next Page
Loading...
