LP9 Suspended Installation Guide 8 of 11 102-000026 - IG090320-A.0
Installation: Connecting Multiple
Sections (Cont.)
Tighten joiner screws, as shown, using a 1/8” Hex Key.
Ensure each section is properly aligned, and that there
are no gaps between sections
17
Mitered Corners: Tighten Joiner Screws
Align sections and join, as shown. CAUTION: Take care not
to pinch wires.
16
Mitered Corners: Align & Join Sections
Re-install each metal cover. CAUTION: Do not pinch wires
while reattaching!
19
Re-install Cover
Tighten joiner screws, as shown, using a 5/64” Hex Key.
Ensure each section is properly aligned, and that there
are no gaps between sections..
15
Tighten Joiner Screws
Adjust Down-Light aiming, parallel and perpendicular
direction are available, as shown.
20
Downlight direction.
Connect wiring quick-connects between sections. Match
each color, as shown. NOTE: Color combinations may
vary.
18
Connect Wiring Between Sections
SHOCK HAZARD! May result in serious injury or death. Turn
power OFF at circuit breaker prior to installation or servicing.
To Next Page
Loading...