3
With your metal detector, you can hunt for coins, relics, jewellery, gold, and silver just
about anywhere. The detector is versatile and easy to use.
The detector’s features include:
LCD Display – shows the probable type of metal with an arrow, the depth of the target,
DISC range, the level of SENS with segment, the operating mode, and battery indication.
Three Tone Audio Discrimination – sound distinctive tomes for different types of
metal.
DISC – ignores junk metal and finds valuable items by setting the DISC range.
P/P – pinpoints the accurate location of the target detected.
Headphone Jack (3,5mm) – let you connect headphones (not supplied) and operate
without trouble.
Power – requires two 9V alkaline batteries (not included).
Waterproof Search Coil – lets you use the detector even if you must put it under water.
Preparation
Assembling the detector
Assembling your detector is easy and requires no special tools. Just follow these steps.
1) Insert the coil cable plug into the 5-pin jack connected with S stem.
• Sheathe the lower stem on S stem and secure with the fixing knob.
• Turn the stem’s locknut clockwise until it loosens. Lengthen or shorten the stem
so when you stand upright with the detector in your hand, the search coil is level
with and about one half to 2 inches above the ground with your arm relaxed at
your side.
• Then turn the stem’s lock mut counter-clockwise to lock
it in place.
• Loosen the knobs at the search coil’s end, then adjust
the search coil to desired angle. (The search coil should
Control box
To Next Page
Loading...
