Need help?Do you have a question about the Amada Promecam ITS 50/12 and is the answer not in the manual?
General| Brand | Amada Promecam |
|---|---|
| Model | ITS 50/12 |
| Category | Power Tool |
| Language | English |
Provides essential safety rules and precautions for operating press brakes.
Specifies requirements for a stable and disturbance-free electrical power supply for proper operation.
Covers grounding requirements and earthing connectors for electrical safety and noise reduction.
Outlines requirements for the pneumatic system, including pressure, flow rate, and supply diagram.
Procedures and guidelines before handling and installing the machine, including floor prep.
Lists specific machine components where handling accessories must not be attached.
Basic principles and methods for safely lifting and moving the machine.
Guidelines for proper use of slinging points and load distribution during lifting.
Overview of the back gauge assembly, its mechanical parts, motor, and safety features.
Step-by-step instructions for powering up the machine and initiating the control system.
Explains the different operational cycles and their sequence breakdown.
Describes the function of each key on the Numerical Control panel.
Instructions for operating the light guard safety system, including modes and indicators.
Steps for resetting the light guard after an interruption or fault.
Details operation in "Single Break" mode, including control settings and cycle progression.
Instructions for operating the machine in "Double Break" mode.
Key safety notes regarding guard reset, mute position, and distance bars.
Crucial instructions to prevent accidents during bending operations.
Explains setting required force using the regulator and checking on the pressure gauge.
Describes setting bending depth by controlling the beam stoppage point.
General instructions for operating the MB numerical control system.
Steps for operating the machine in manual mode, including unit selection and axis control.
Guide to entering programming mode, selecting programs, and entering axis values.
Steps to select, load, and run a programmed bend sequence.
Methods for correcting bend parameters.
Steps to delete an entire program.
Procedure for saving programs to external memory.
How to load programs from external memory.
Instructions for using the teaching mode to set axis positions.
Introduction to the self-diagnostic software for checking control components.
Steps to enter and initiate the self-diagnostic mode.
Lists the types of checks performed during self-diagnosis.
Lists common error codes and their meanings for the MB numerical control.
Table of failures, causes, and corrective actions for common issues.
Flowchart for programming a part, including back-up and deletion.
Detailed steps for programming bend dimensions and sequences.
Procedure to find and store the pinch dimension in manual mode.
Procedure to find and set the bending depth value.
Steps for finding pinch dimension in manual mode.
To Next Page