Need help?Do you have a question about the Amada Promecam ITS 80/25 and is the answer not in the manual?
Essential instructions for safe operation and pre-operation checks.
Critical guidelines and warnings to prevent operator injury during use.
Specifies requirements for stable power supply and electrical installation.
Specifies requirements for a stable, rigid ground surface and flooring.
Pre-installation instructions for floor preparation and forbidden handling operations.
Principles and accessories for lifting and moving the machine safely.
Important notes on handling, bearing points, and guarantee suspension.
Step-by-step guide to correctly level the machine using shims and spirit level.
Process for machine commissioning by a technical department, including test plates.
Instructions on how to use the light guard safety system.
Procedures for mounting dies and punches, including assembly and flattening.
Crucial recommendations to avoid accidents and ensure proper operation.
How to set the pressure regulator to achieve the required force for bending.
How to set the hydraulic gauge block control for bending depth.
Steps for entering axis values, withdrawal times, and machine functions for programming.
List of error codes and their corresponding meanings for troubleshooting.
Table of failures, possible causes, and corrective actions.
General overview and flowchart for programming a part.
Detailed steps for programming bend dimensions and parameters.
Maintenance of the hydraulic system, including drainage and filling procedures.
Lubrication and cleaning procedures for the rear gauge assembly.
General| Brand | Amada Promecam |
|---|---|
| Model | ITS 80/25 |
| Category | Power Tool |
| Language | English |
To Next Page