Need help?Do you have a question about the Amada Promecam ITS 50/20 and is the answer not in the manual?
Details the basic safety equipment included with press brakes.
Provides crucial instructions for the safe operation and use of press brakes.
Specifies requirements for a stable and disturbance-free electrical power supply.
Provides guidance on preparing the installation floor and lists forbidden operations during handling.
Covers safety standards and elements for selecting cycle and control mode for the light guard.
Introduces the MB numerical control as an option for productivity enhancement.
Defines bending technique (air bending or coining) before carrying out operations.
Lists essential safety recommendations to avoid accidents during bending operations.
Explains how to set the pressure regulator to achieve the required force and check it on the gauge.
Details how to set the bending depth by stopping the moving beam at a selected point.
Covers machine startup, display messages, and initial origin setting operations.
Explains manual mode operation for X, Y axes, and rear gauge stop fingers.
Guides through programming mode, selecting programs, and entering axis values.
Details the self-diagnostic software program for checking component status.
Lists and explains various error messages encountered during operation.
Provides a table of failures, possible causes, and corrective actions.
Guides through the process of programming a part, including selecting programs and saving data.
Details how to program bends, including edge dimension and penetration value.
Explains how to find and set the pinch dimension in manual and programming modes.
Describes how to find and set the bending depth value for operations.
Covers the production phase after programming, including bend positioning and sequence.
General| Brand | Amada Promecam |
|---|---|
| Model | ITS 50/20 |
| Category | Power Tool |
| Language | English |
To Next Page