Amana AB2225PEK Series User Manual (English)

Questions and Answers:

K
khollandAug 25, 2025
Why is the freezer and refrigerator section of my Amana AB2225PEK too warm?
- J
  James AllenAug 26, 2025
  If both the freezer and refrigerator sections of your Amana Refrigerator are too warm: * The temperature controls might be set too warm; reset them. * A poor door seal could be the issue; level the cabinet, adjust the hinges, and replace the gasket if necessary. * A dirty condenser or obstructed grille could be the cause; check and clean them. * A faulty control might be the reason; test the control and replace it if it has failed. * A refrigerant shortage or restriction could be the issue; check for leaks or restrictions, and repair, evacuate and recharge the system.
L
Laura ParkerAug 28, 2025
What should I do if my Amana AB2225PEK Refrigerator section is too cold?
- D
  Donald GonzalezAug 28, 2025
  If your Amana Refrigerator section is too cold: * The refrigerator temperature control might be set too cold; adjust it. * The refrigerator airflow may not be properly adjusted; check the air flow.
A
Amanda PatrickSep 1, 2025
What to do if my Amana AB2225PEK Refrigerator freezer section is too cold?
- C
  colleen49Sep 1, 2025
  If your Amana Refrigerator's freezer section is too cold: * The freezer temperature control may be set too cold. Adjust the freezer temperature control. * A faulty control may be the cause. Test the control and replace it if it has failed.
J
Jacqueline LandrySep 5, 2025
What causes my Amana AB2225PEK Refrigerator to run continuously and be too cold?
- A
  andrewpittmanSep 5, 2025
  If your Amana Refrigerator runs continuously and the temperature is too cold, a faulty defrost thermostat could be the cause. Check the thermostat and replace it if necessary.
L
Louis GarzaSep 8, 2025
Why is my Amana AB2225PEK unit not running?
- S
  Suzanne JacksonSep 9, 2025
  Your Amana Refrigerator might not be running due to several reasons: * There may be no power to the unit. Check the outlet and the fuse box/circuit breaker. * A faulty power cord could be the issue. Use a test light to check for a circuit at the unit. * Low voltage could be the cause. Ensure the input voltage is correct. * A faulty motor, relay, or compressor could also be the reason. Check all connections, test the components, and replace if necessary. * A faulty overload may be the reason. Check overload for continuity. Be sure the compressor/overload are below trip temperature before testing. Replace if needed.