Amana AMES960603BNAA - User Manual

Service and Troubleshooting
GMES9*/GCES9*/AMES9*/ACES9*/VMES9*/VCES9*

Copyright © 2019-2020 Goodman Manufacturing Company, L.P.
This manual is to be used by qualied, professionally
trained HVAC technicians only. Goodman does not assume
any responsibility for property damage or personal injury
due to improper service procedures or services performed
by an unqualied person.
RS6612016r3
April 2020
®
is a registered trademark of Maytag Corporation or its related companies and is used under license.
All rights reserved.
TABLE OF CONTENTS
IMPORTANT INFORMATION ............................................ 2
PRODUCT IDENTIFICATION ........................................... 4
SYSTEM OPERATION ...................................................... 7
SCHEDULED MAINTENANCE ....................................... 28
SERVICING ..................................................................... 31
ACESSORIES ................................................................. 47
TROUBLESHOOTING CHART ....................................... 51
WIRING DIAGRAMS ....................................................... 54
Pride and workmanship go into every product to provide
our customers with quality products. It is possible, however,
that during its lifetime a product may require service.
Products should be serviced only by a qualied service
technician who is familiar with the safety procedures
required in the repair and who is equipped with the proper
tools, parts, testing instruments and the appropriate service
manual. 
















WARNING
WARNING


Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
0140M00517-A

Summary

Important Information

Carbon Monoxide Poisoning Hazard

Warning about carbon monoxide poisoning hazards and precautions.

System Operation

Safety

Combustion and Ventilation Air Requirements

Critical requirements for fresh air for proper combustion and ventilation.

Propane Gas and;or High Altitude Installations

Vent;Flue Pipe and Combustion Air Pipe

Instructions and warnings for proper installation of vent/flue and combustion air pipes.

Gas Supply and Piping

Electrical Connections

Safety precautions and requirements for electrical connections, including grounding.

Heating - Abnormal Operation

Lists common heating operational problems and their probable causes.

Servicing

S-16 A Checking Air Circulator Blower Motor (Multi-Speed ECM Motor)

S-300 Checking Primary Limit Control

S-302 Checking Flame Rollout Control

Procedure for checking the flame rollout control for trips and voltage.

S-303 Induced Draft Blower Motor

S-304 Checking Gas Valve (Redundant)

S-307 Checking Gas Pressure

Procedure for measuring and adjusting inlet gas supply pressure.

S-308 Checking Hot Surface Ignitor

S-309 Checking for Flashback

Steps to diagnose and identify the causes of burner flashback.

S-310 Checking Pressure Switch

Procedure to test the pressure switch and check for adequate negative pressure.

S-312 Checking for Delayed Ignition

Checks to perform if delayed ignition occurs during furnace operation.

S-313 Checking Integrated Ignition Control Boards

Steps for testing the integrated ignition control board for faults and voltage.

S-314 Checking Flame Sensor

Troubleshooting

Amana AMES960603BNAA Specifications

General

Brand	Amana
Model	AMES960603BNAA
Category	Furnace
Language	English