To Next PageTo Next Page
Need help?Do you have a question about the Amana AVPVC60D14 Series and is the answer not in the manual?
General| HSPF | Up to 10 |
|---|---|
| Refrigerant | R-410A |
| Voltage | 208/230 V |
| Phase | 1 |
| Fan Motor Type | ECM |
| Sound Level | As low as 57 dBA |
| Type | Split System Heat Pump |
Provides safety warnings and instructions for testing and identifying capacitor issues.
Troubleshooting chart for cooling mode, listing possible causes and their indicators.
Troubleshooting chart for heating mode, listing possible causes and their indicators.
Procedure for running the initial system test to verify equipment settings and functionality.
Procedure for entering pump down mode to accumulate refrigerant for service.
Instructions for checking compressor winding resistance and insulation integrity.
Detailed steps for evacuating the refrigeration system to remove air and moisture.
Instructions for charging the system with the correct amount of refrigerant.
Method to diagnose compressor inefficiency based on pressure and amp readings.
Procedure for checking superheat levels to ensure proper TXV operation.
Procedure for measuring subcooling to verify refrigerant charge and TXV performance.
Procedure for diagnosing compressor burnout and analyzing oil for acidity.
Safety guidelines for preventing electrostatic discharge damage to electronic components.
Overview of diagnostic codes displayed on the 7-segment LED for system troubleshooting.
Detailed explanations of indoor unit error codes, their causes, and corrective actions.
Procedures for system verification tests, force defrost cycles, pump down, and charge mode.
Instructions for activating heating emergency mode when thermostat communication fails.
Procedure for activating cooling emergency mode without thermostat communication.
Comprehensive list of outdoor unit error codes, their probable causes, and corrective actions.
Step-by-step instructions for rewriting shared data to the outdoor unit using a memory card.
Chart correlating R-410A refrigerant pressure (PSIG) with temperature (°F).
Table showing required liquid line temperature based on liquid pressure and subcooling.
Wiring diagram for the AVZC200241** 2-ton model.
Wiring diagrams for the AVZC200361** and AVZC200481** 3-4 ton models.
