Amana CRC18T2OG User Manual

RS2240002 Rev. 1 16
Numbered Pads Display Options (Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12
3 second continuous beep.
Continuous beep until door is opened.
5 beeps bursts until door is opened.
2
Speaker Volume
OP:20
OP:21
OP:22
OP:23
Eliminates beep.
Sets volume to low.
Sets volume to medium.
Sets volume to high.
3
Key Beep
OP:30
OP:31
Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Keyboard Enable
Window
OP:40
OP:41
OP:42
OP:43
15 seconds after oven door is opened, keyboard disabled.
30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
2 minutes after oven door is opened, keyboard disabled.
5
Add Time during
Heating
OP:50
OP:51
Prevents adding heating time while oven is heating.
Allows heating time to be changed while oven is heating
when a memory pad is pressed.
6
Reset Door Open
OP:60
OP:61
Allows oven to resume heating time countdown after door is
opened during cycle.
Cancels heating time countdown after door is opened during cycle.
7
Maximum Heating
Time
OP:70
OP:71
Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81
Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
Double Digit
Operation
OP:90
OP:91
Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
User Options
Follow the instructions below to customized the
microwave oven’s operation. End-of-cycle signal,
maximum cooking time and other options can be
changed to meeting your cooking needs. Example:
Change setting to single digit pad operation.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
“0P:”.
3. Press 9 pad.
• See table for options.
• Displays shows “OP:91”.
• “OP” represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
4. Press 9 pad repeatedly to change setting.
5. Press START pad to save changes.
• Repeat steps 3-5 to change additional options.
• Changes appear after door is closed or STOP/
RESET is pressed.
6. Press STOP/RESET pad or close oven door to exit
programming mode.
Programming Instructions

Amana CRC18T2OG Specifications

General

Brand	Amana
Model	CRC18T2OG
Category	Microwave Oven
Language	English