RS2240002 Rev. 0 A–10
Unpacking Oven
• Inspect oven for damage such as dents in door or dents
inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.
Radio Interference
Microwave operation may cause interference to radio,
television, or similar a oven. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in “Care and Cleaning” section.
• Place radio, television, etc. as far as possible
from oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
Oven Placement
• Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
• Install oven on level countertop surface.
A
B
A
A
B
A
A—Allow at least 7 " (17.8 cm) of clearance around top and
sides of oven. Proper air flow around oven cools electrical
components. With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B—Allow at least 2
9
/16 " (6.5 cm) between air discharge on back
of oven and back wall.
Oven Clearances
To Next Page
Loading...
