To Next PageTo Next Page
Need help?Do you have a question about the Amana GUIB070CX30 and is the answer not in the manual?
General| Brand | Amana |
|---|---|
| Model | GUIB070CX30 |
| Category | Furnace |
| Input BTU | 70, 000 BTU |
| Stages | Single Stage |
| Fuel Type | Gas |
| Heating Capacity | 70000 BTU |
| Heat Exchanger Warranty | Lifetime |
| Parts Warranty | 10 Years |
Key safety warnings and disclaimers for service.
Lists of model numbers and their corresponding manufacturing numbers.
Technical data including input, output, AFUE, and pressure for GUIA models.
Technical data including input, output, AFUE, and pressure for GUIB models.
Technical data including input, output, AFUE, and pressure for GUIC models.
Technical data including input, output, AFUE, and pressure for GUID models.
Technical data including input, output, AFUE, and pressure for GCIA models.
Technical data including input, output, AFUE, and pressure for GCIB models.
CFM and temperature rise data for single-stage furnaces at various ESP.
CFM and temperature rise data for two-stage furnaces.
CFM and speed data for variable speed two-stage furnaces.
Rules for providing adequate air for combustion and ventilation.
Guidelines for connecting natural gas and propane supply lines.
Instructions for proper electrical connections and accessory wiring.
Typical wiring configurations for single-stage and two-stage thermostats.
Step-by-step process for normal heating and cooling operation.
Troubleshooting common furnace malfunctions and diagnostic codes.
Detailed chart linking symptoms, codes, causes, and corrective actions.
Troubleshooting specific to Radiant Sense ignition controls.
Step-by-step heating sequence for GUIS/GCIS two-stage furnaces.
Troubleshooting for GUIV variable speed furnaces with diagnostic codes.
Step-by-step heating sequence for GUIV variable speed furnaces.
Recommended annual checks for furnace components and safety.
Procedure to calculate BTU input and assess heating performance.
Steps to measure line and low voltage for troubleshooting.
Procedures for testing the automatic reset primary limit control.
How to test and reset the auxiliary limit control.
Procedures for testing and resetting the flame rollout switch.
How to test the pressure switch for proper operation.
Procedures for testing the circulator and induced draft blower motors.
Troubleshooting the White-Rodgers and Heatcraft integrated ignition control modules.
Troubleshooting for Radiant Sense ignition controls and their modules.
Procedures for testing the flame sensor and ignition control module.
Procedures for measuring and adjusting inlet gas supply pressure.
Steps to measure and adjust gas manifold pressure for natural gas.
