To Next PageTo Next Page
Need help?Do you have a question about the Amana GUIA070A30 and is the answer not in the manual?
General| Brand | Amana |
|---|---|
| Model | GUIA070A30 |
| Category | Furnace |
| Type | Gas |
| Heating Capacity | 70, 000 BTU |
| Input BTU | 70, 000 BTU |
| Blower Motor | Multi-Speed |
| Stages | Single Stage |
| Ignition | Electronic |
| Warranty | Limited Lifetime Heat Exchanger |
| Fuel Type | Natural Gas |
Warnings and disclaimers regarding service safety and responsibility.
Explanation of safety symbols and their meanings.
Lists model/M/N pairs for part identification.
Lists various furnace accessory kits and items.
Explains the coding system used in model numbers.
Technical data for GUIA furnace models.
Technical data for GCIA furnace models.
Technical data for GUIBA furnace models.
CFM and temperature rise data for single-stage models.
CFM and temperature rise for two-stage models.
Cooling and heating speed charts for variable speed models.
General provisions and requirements for air supply.
Specific air supply methods for confined spaces.
Factors affecting free area calculations for openings.
Guidelines for connecting gas supply and piping.
Adjustments for furnace operation at high altitudes.
Instructions for electrical connections and accessories.
Step-by-step heating operation for integrated controls.
Troubleshooting furnace issues via diagnostic codes.
Timing diagrams for GUIS/GCIS two-stage operation.
Essential tools for accurate diagnosis and repair.
Procedure to calculate BTU input for performance analysis.
Procedures for measuring inlet and manifold gas pressures.
Factory wiring for blower motors to the control module.
Schematic for the common vent kit wiring.
Schematics for furnace twinning kits (FTK02A/FTK03A).
Schematics for White-Rodgers and Heatcraft ignition controls.
Wiring schematic for the CVK4-7 common vent kit.
Schematics for furnace twinning kits (FTK02A/FTK03A).
