To Next PageTo Next Page
Need help?Do you have a question about the Amana PTAC and is the answer not in the manual?
General| Refrigerant | R-410A |
|---|---|
| Heating Type | Electric or Heat Pump |
| Voltage | 208/230V |
| Weight | approximately 120 lbs |
| Type | Packaged Terminal Air Conditioner (PTAC) |
| Unit Dimensions | 42" W x 16" H x 13 3/4" D |
Instructions on removing the sleeve stiffener and rear closure panel.
Proper methods for installing the wall sleeve for water drainage.
Instructions for installing the outdoor grille for proper airflow and protection.
Procedure for removing the cabinet front for access to internal components.
Steps to insert and secure the unit chassis into the wall sleeve.
Critical electrical wiring procedures and safety precautions.
How to measure unit supply voltage and acceptable ranges.
How to operate the unit using the control panel and its features.
Explains the six-button touchpad for temperature and mode control.
How to adjust temperature using COOL and HEAT controls with arrows.
How to select high, low, or auto fan speed.
Details the various terminals and connections on the control board.
How the vent control manages outside air intake for ventilation.
How to configure and operate the unit with a remote thermostat.
Describes the functions of the OFF, HEAT, and COOL settings on the thermostat.
Instructions for monthly cleaning of the intake air filter.
Procedure for cleaning the vent screen, requiring chassis removal.
Guidelines for annual cleaning and inspection of unit components.
Steps for thorough unit cleaning, including coils and basepan.
Detailed steps for cleaning the basepan and condenser coil, including precautions.
Step-by-step guide to enter the configuration feature mode.
Configures unit control via touchpad, wireless, or wired thermostat.
Procedure to enter the diagnostic status report mode.
How to view various temperature readings within the unit.
How to access and review the last 10 failure codes.
