Amana RCS10 User Manual

13
1
3
X2 Quantity Feature(some models)
This feature allows the user to change the amount of time
added when the X2 pad and then the programmed pad is
pressed. Based on the original time, the X2 pad can add
from 10%–100% of additional cooking time. The default is
80%. Example: change cooking factor to 50% for third
cooking sequence.
1. Open oven door.
• If door is closed or RESET pad is
pressed before finishing programming
sequence, oven exits programming
mode.
2. Press and hold pad 1 for approximately
5 seconds.
• After 5 seconds, signal sounds.
Display shows
“P:” (“P:0” if in double pad
programming mode).
3. Press 3 pad to select the cooking
program.
4. Press the X2 pad.
5. Press 5 pad to change cooking factor.
• Display shows “CF:05”.
• Numbered pads change cooking factor
in increments of 10. Example: number
pad 1, sets cooking factor to 10%,
number pad 2 sets cooking factor at
20%.
6. Press START pad to save changes.
7. Press STOP/RESET pad or close oven door to exit
programming mode.
1
3
X2
5
START
STOP
RESET
Multiple Cooking Stages (some models)
Follow instructions below to program oven to perform up
to four consecutive cooking cycles without interruption.
Example: Program third cooking sequence to heat for 30
seconds at 20% power, 40 seconds at 50% power, and
10 seconds at 100% power.
1. Open oven door.
• Display shows “READY”.
• If dooris closed or RESET pad is pressed before
finishing programming sequence,
oven exits programming mode.
2. Press and hold pad 1 for
approximately 5 seconds.
• After 5 seconds, signal sounds.
Display shows “P:” (“P:0” if in double
pad programming mode).
3. Press 3 pad to select memory pad.
• Display shows cooking time and
power level if other than 100 percent
power.
4. Press 3 and 0 to enter desired cooking
time.
5. Press POWER LEVEL pad to change
power level.
• Display shows current power level if
other than 100 percent power.
6. Press TIME ENTRY pad.
• Display briefly shows "P:03
(1-4)
"
indicating programming, pad 3, stage
2. Then cook time and power level for
stage show in display.
• Repeat steps 5–7 to create additional
stages.
7. Press START pad to save new cooking
time and power level in oven memory.
8. Press STOP/RESET pad or close oven
door to exit programming mode.
DEFROST
20%
3
0
TIME
ENTRY
START
STOP
RESET

Amana RCS10 Specifications

General

Brand	Amana
Model	RCS10
Category	Microwave Oven
Language	English