Amana RCS10 User Manual

14
Numbered Pads Display Options (Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12
3 second continuous beep
Continuous beep until door is opened
5 beeps bursts until door is opened
2
Speaker Volume
(Not Available on
RCS10)
OP:20
OP:21
OP:22
OP:23
Speaker off, no beep sounds
Sets volume to low
Sets volume to medium
Sets volume to high
3
Key Beep
OP:30
OP:31
No beep when pad is pressed.
Sound beep when pad is pressed.
4
Keyboard Enable
Window
OP:40
OP:41
OP:42
OP:43
15 seconds after oven door is opened, keyboard disabled
30 seconds after oven door is opened, keyboard disabled
1 minute after oven door is opened, keyboard disabled
2 minutes after oven door is opened, keyboard disabled
5
Add Time during
Heating
OP:50
OP:51
Prevents adding heating time while oven is heating.
Allows heating time to be changed while oven is heating when a
memory pad is pressed.
6
Reset Door Open
OP:60
OP:61
Allows oven to resume heating time countdown after door is
opened during cycle.
Cancels heating time count down when door is opened during cycle.
7
Maximum Heating Time
(Not Available on
RCS10)
OP:70
OP:71
Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81
Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
Double Digit Operation
(Not Available on
RCS10 and RCS10MP)
OP:90
OP:91
Allows 10 (0–9) preprogrammed pads.
Allows 100 (00–99) preprogrammed pads.
START
STOP
RESET
3. Press 9 pad.
• See table below for options.
• Displays shows “OP:91”.
• “OP” represents optional program
mode, first number represents option
number and second number represents
functions currently selected for option.
4. Press 9 pad repeatedly to change
setting.
5. Press START pad to save changes.
• Repeat steps 3–5 to change additional options.
• Changes appear after door is closed or STOP/
RESET is pressed.
6. Press STOP/RESET pad or close oven door to exit
programming mode.
2
9
User Options
Follow the instructions below to customize oven
operation. End-of-cycle signal, maximum cooking time
and other options can be changed to meeting your
cooking needs. Example: Change setting to single digit
pad operation.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5
seconds.
• After 5 seconds, signal sounds.
• Display shows “0P:”.

Amana RCS10 Specifications

General

Brand	Amana
Model	RCS10
Category	Microwave Oven
Language	English