Attention Installer Amana cannot be responsible for improper installation
1. Prepare Location
• Make sure cutout floor is level. If floor is not level it is
necessary to shim rear wheels onto a piece of plywood
or other shim material so refrigerator is level.
!
WARNING
To avoid electrical shock which can cause severe personal
injury or death, disconnect power outlet from main power
supply before installing or servicing refrigerator.
Shim refrigerator
wheels as needed
2.Prepare refrigerator for
delivery
Some installations may require door removal to get
refrigerator into home.
1. Remove toe grille
2. Remove top hinge cover and top hinge.
Dispensing and Electronic Models
!
WARNING
To avoid electrical shock which can cause severe personal injury or
death, green ground wire must remain attached to hinge.
• Disconnect wire connectors (A).
Loosen water tube clamp (B). Loosen water tube union nut (C).
Pull water tube away from union nut and through tube clamp.
• Unplug electrical connector from voltage box (D).
3. Remove doors (E).
• Remove top hinges (F).
• Remove doors from bottom hinge (F).
• Remove bottom hinge (F).
!
CAUTION
To avoid floor and wall damage protect walls and soft vinyl or other
flooring with masonite or other protective material when moving the
refrigerator.
4. Attach refrigerator to appliance cart (G).
B
C
A
D
Bottom
right
Bottom
left
E
F
G
3.Install refrigerator
1. Reinstall doors by performing section 2 in reverse order.
2. Connect ice maker water supply line (Refer to
Installation
Instructions
in
Owner’s Manual
.)
3. Plug power cord into electrical receptacle.
4. Stabilize refrigerator and align doors.
If refrigerator rocks or is not stable on floor perform
the following:
• Determine which rear corner is rocking.
A
B
C
"P" clamp
Copper
tubing
Brass nut
Brass sleeve
Water valve
inlet connection
4.Prepare refrigerator for use
1. Remove all interior packaging material 2. Clean interior and exterior of refrigerator
3. Instruct consumer on controls and features. 4. Verify power to refrigerator is connected.
Part No. 12123314
Printed in U.S.A.
©
1998 Amana Appliances
Amana IA. 52204
• Remove toe grille to gain access to roller adjustment screws.
• Turn rear roller adjustment screw (A) clockwise to raise corner that is rocking.
• Check alignment of top of doors. If doors are level replace toe grille.
If tops of doors are not level perform the following steps:
• Determine which door must be raised (if toe grille has not been removed,
remove at this time).
• Turn front roller adjustment screw (B) clockwise to raise front corner of door
that needs to be raised. Roller adjustment screw should be turned until doors
are level (C).
• Replace toe grille.
Need help?
General
