EasyManua.ls Logo

Amana Room Air Conditioner & Heat Pump User Manual

Amana Room Air Conditioner & Heat Pump
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
is a registered trademark of Maytag Corporation or its related companies
and is used under license to Goodman Company, L.P., Houston, TX. All rights reserved.
Room Air Conditioner & Heat Pump
Use and Care Manual
Introduction
Room air conditioners cool, dehumidify, and filter air inside
your home. Heat pump and electric heat models offer both
heating and cooling. Opening sections of manual provide
general information for all room air conditioner models.
Operating Controls section describes operation of controls
for each model. After reading the opening sections, turn to
Operating Controls section and find the panel layout that
matches the model of your unit.
Read entire manual thoroughly before beginning installation
and operation of your new room air conditioner. Be sure you
have all necessary tools and materials on hand for the job.
Study illustrations to familiarize yourself with important
details of the installation process. Review manual for oper-
ating instructions.
NOTE
1. Mechanical experience is required to install air condi-
tioner.
2. Installation can take from 1 to 3 hours, depending on
installer’s knowledge and skill.
3. If you encounter problems during installation, call our
consumer information line toll-free at 1-877-376-0214. If
your problem cannot be resolved by phone, contact an
authorized Amana
®
brand servicer. Contact and service
will be at your expense.
IO-372A
©2010 Goodman Company, L.P.
Effective: May 2010
Safety Information
Be sure electrical service is adequate for chosen model of air
conditioner. Complete electrical rating for unit is found on
serial plate located behind front grille. Electrical outlet must
be close enough to unit for power cord to reach without strain.
Air conditioner should be the only appliance on individual
circuit.
For personal safety and to avoid possible damage to appli-
ance or home, observe all safety instructions highlighted by
symbol shown below.
RECOGNIZE THIS SYMBOL AS A
SAFETY PRECAUTION.
After installing unit, reread instructions to ensure each step
is complete and that all parts are fastened in place. For best
results and to minimize installation time, perform all proce-
dures in the order shown.
WARNING
Contents
Introduction .................................................................. 1
Safety Information ....................................................... 1
Unpacking .................................................................... 2
Electrical Requirements.............................................. 2
Installation ................................................................... 3
Room Heat Pumps ....................................................... 3
Normal Care & Maintenance ...................................... 3
General Instructions .................................................... 5
Installation Instructions ............................................... 6
Through-The-Wall Installation Instructions ............. 12
Operating Controls .................................................... 15
Before Calling Service .............................................. 17
When Service Is Required ........................................ 18
Any Questions? .......................................................... 18
Warranty..................................................................... 20
Question and Answer IconNeed help?

Do you have a question about the Amana Room Air Conditioner & Heat Pump and is the answer not in the manual?

Amana Room Air Conditioner & Heat Pump Specifications

General IconGeneral
TypeRoom Air Conditioner & Heat Pump
Cooling CapacityVaries by model
Heating CapacityVaries by model
Energy Efficiency Ratio (EER)Varies by model
Heating Seasonal Performance Factor (HSPF)Varies by model
Voltage115V or 230V (depends on model)
Noise LevelVaries by model
Dimensions (H x W x D)Varies by model
WeightVaries by model
Warranty1-year limited warranty

Summary

Introduction

Safety Information

Key safety precautions for operating the air conditioner and heat pump.

Installation Instructions

Guidance on preparing for and executing the installation process.

Operating Controls

Explanation of how to use the various controls on the unit.

Owner's Product Identification

Warning - High Temperature Stress Hazard

Caution regarding unattended cooling and risks of extreme heat.

Unpacking Instructions

Steps for unpacking the unit and checking for damage.

Electrical Requirements and Grounding

Essential electrical specifications and proper grounding procedures.

Receptacle Wiring and Power Cords

Receptacle Wiring

Guidelines for ensuring adequate wiring for the unit's power requirements.

LCDI or AFCI Power Cords

Explanation of current interrupter devices in power cords.

Installation Process Overview

Installation Instructions Overview

Overview of where to find detailed installation steps.

Normal Care and Maintenance

Annual Inspection and Cleaning

Recommendations for yearly inspection and cleaning of the unit.

Front Grille and Filter Removal

Step-by-step guide on how to remove the front grille and air filter.

Air Filter Cleaning

Instructions on how to clean the air filter for optimal performance.

Slide-out Chassis Removal

Procedure for safely removing the unit's chassis from the outer case.

General Operating Instructions

Initial Start-Up and Cooling

Guide to starting the unit and setting the initial cooling temperature.

Drain Cup Installation and Use

How to install and use the condensate drain cup for water management.

Changing Airflow Direction Baffles

Adjusting baffles and louvers to control airflow direction.

Airflow Around Unit

Ensuring unobstructed airflow for efficient operation.

Switchover Thermostat Control

Explanation of the emergency heat switch and its function.

Installation Instructions

Before You Begin Installation

Important preparatory steps and considerations before starting installation.

Electrical Requirements for Installation

Detailed electrical requirements for safe and proper installation.

Tools Required for Installation

List of necessary tools for performing the installation.

Installation Parts Included

Included Installation Components

Identification of all parts supplied with the unit for installation.

Window Installation Requirements

Window Requirements

Specifications and requirements for installing the unit in a window.

Storm Window Adjustments

Adjustments needed if a storm window frame is present.

Unit Removal from Case

Procedure for safely removing the unit from its shipping case.

Window Preparation Steps

Steps to prepare the window opening for the unit.

Case Preparation and Installation

Prepare the Case for Mounting

Steps for preparing the outer case and attaching accordion panels.

Install the Case in the Window

Detailed instructions for mounting the outer case securely in the window.

Window Case Installation Details

Adjusting Case for Drainage

How to achieve the correct slant for condensate drainage.

Install Support Brackets and Foam Gasket

Attaching support brackets and foam for a secure fit.

Installing the Air Conditioner Unit

Install Unit into Case

Procedure for inserting the unit into the prepared case.

Reconnect Power and Attach Grille

Steps for reconnecting power, filter, and front grille.

Thru-wall Installation

Thru-wall Installation Introduction

Introduction to installing the unit through an outside wall.

Air Conditioner and Outer Case Dimensions

Provides crucial dimensions for the unit and its outer case.

Thru-wall Construction and Placement

Wall Construction Requirements

Requirements for brick veneer, frame, or masonry wall construction.

Placement of Outer Case in Opening

Guidelines for positioning and securing the outer case in the wall opening.

Thru-wall Installation for Thicker Walls

Installation in Walls Thicker Than 9-inches

How to install the unit in walls that exceed the standard thickness.

Operating Controls

Power Pad and Display Functions

Functions of the power button and the unit's display screen.

Temperature and Delay Timer Controls

How to adjust temperature and set the delay timer.

Fan Speed and Mode Selection

Options for controlling fan speed and operating modes.

Advanced Operating Features

Setting Timer Functions

How to set the timer for automatic operation or shutdown.

Cooling Mode Descriptions

Explanations of different cooling modes (Normal, Maximum, Quieter).

Energy Saver and Fan Only Modes

How to use Energy Saver and Fan Only modes.

Heat Mode and Auto Fan Speed

Using heat mode and automatic fan speed adjustment.

Before Calling Service

Troubleshooting Common Problems

Lists common issues and their potential causes and suggested remedies.

Unit Performance Issues

Specific steps for when the unit won't run or has poor cooling/heating.

Unit Noise and Mounting Support

Addressing noises and problems with mounting support.

Frost and Odor Resolution

Solutions for frost buildup and unusual odors.

When Service Is Required

Providing Information for Service

What information to provide to the service center for prompt help.

Contacting Consumer Support

Contact details for consumer information and support.

Limited Warranty for Consumers

First-Year Consumer Warranty

Details of warranty coverage for the first year of ownership.

Sealed System Consumer Warranty

Warranty coverage for the sealed system in subsequent years.

Consumer Warranty Limitations

Limitations, exclusions, and conditions that may void the warranty.

Warranty for Commercial Customers

First-Year Commercial Warranty

Warranty coverage for commercial customers in the first year.

Sealed System Commercial Warranty

Warranty coverage for the sealed system for commercial use.

Commercial Warranty Limitations

Limitations and exclusions specific to commercial warranty coverage.

Related product manuals