8
Door Open Alarm
Door open alarm sounds and glowing indicator light
blinks if either door is open for three minutes.
Deactivate door open alarm by pressing Alarm Off pad or
by closing either door. Activate door open alarm by
pressing * pad then holding Alarm Off pad for three to
five seconds. Three short beeps will sound. Repeat
above to deactivate door open alarm indefinitely.
High Temperature Alarm
High temperature alarm sounds and indicator light
glows if Fresh Food or Deepfreeze
®
temperature is high
for two hours. A blinking light signals affected
compartment. Deactivate high temperature alarm by
pressing Alarm Off pad. Alarm discontinues when
proper temperature is reached.
Thermistor Alarm
Thermistor alarm sounds and indicator lights scroll if
Fresh Food or Deepfreeze
®
thermistor is not operating
properly. Deactivate display by pressing Alarm Off pad.
If thermistor alarm sounds, contact an authorized
servicer immediately. If Alarm Off pad is pressed,
thermistor control retests to confirm situation has been
corrected. Alarm sounds again if thermistor is still not
operating properly.
Display Lights
Deactivate temperature display lights by pressing * pad
then pressing Display Off pad. Activate temperature
display lights by pressing any of top five pads.
Clean Condenser Coil Light
Clean condenser coil light glows once every three
months as a reminder to clean condenser coil. Light
automatically cancels in 72 hours. Deactivate clean
condenser coil light before automatic reset by pressing
Alarm Off pad.
Automatic Ice Maker
Refrigerator has an electrical connection in Deepfreeze
®
section for ice maker installation. Ice maker, model
IC54, and water filter, part #R0183114, can be
purchased separately.
1. Confirm ice storage bucket is in place and ice
maker arm is down.
2. After Deepfreeze
®
section reaches normal
temperature, ice maker fills with water and
begins operating. Allow 24-48 hours after
installation before first harvest of ice. Ice maker
produces seven to nine harvests of ice in a
24-hour period under ideal conditions.
3. After ice is formed, ice maker drops ice cubes
into ice storage bucket. During ice production,
ice maker arm raises and lowers. When ice
storage bucket is full, ice maker arm turns ice
maker off.
Important
Discard first three harvests of ice so any impurities are
not consumed.
4. Stop ice maker by lifting ice maker arm. A
definite click will be heard when proper position
is reached. Ice maker arm will remain in that
position.
Important
Do not force ice maker arm down or up past stop
position.
To Next Page
Loading...
Need help?
General
