RS5290000 Rev. 0 102 April 1998
Kit Instructions
Procedure
Caution
To avoid personal injury or property damage, two
people should remove and rehang each door.
Caution
To avoid personal injury, protect hands and arms. Trim
pieces may have sharp edges.
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
2. Dispenser Models
Remove crushed/cubed ice switch cover on
dispenser by pulling forward. Remove screws from
bottom of dispenser cover. Release bottom clips on
dispenser cover by placing taped edge of putty knife
underneath cover and pulling out. Release top clips
by holding bottom of dispenser cover out and slide
upward.
3. Remove door handle inserts by placing screwdriver
at top of door handles in area between handle and
insert and pulling out.
4. Pull edge of inserts forward along length of handles.
Caution
To avoid personal injury or property damage, hold
handles when removing.
5. Remove door handles by removing screws. Bottom
inserts are removed with handle.
To Next Page
Loading...
