RS5290000 Rev. 0 82 April 1998
Kit Instructions
19. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against top
corner of refrigerator cabinet over edge of top trim.
After checking placement, peel off backing and
press into place. Place side door trim over edge of
bottom trim.
20. Push water tube into plastic union nut and tighten
union nut by hand. Gently pull on tube to confirm
nut is tight. Tighten water tube clamp screw.
Caution
To avoid property damage, confirm water tube union
nut is secure and check for leaks before replacing toe
grille.
21. Replace toe grille by inserting clips in holes and
snapping in.
To Next Page
Loading...
