RS5290000 Rev. 0 94 April 1998
Kit Instructions
Procedure
!
CAUTION
To avoid personal injury, protect hands and arms. Trim
pieces may have sharp edges.
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
Introduction
!
CAUTION
To avoid personal injury and property damage,
observe all safety instructions.
!
CAUTION
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material.
Read entire manual before installing kit. Confirm all parts
listed are included in kit. If parts are missing, contact
source from whom kit was purchased.
Important
• Mechanical experience is required to install trim kit.
• Depending on installer’s knowledge and skill,
installation can take from one-half to one hour.
• If unable to solve a problem during installation,
contact source from whom kit was purchased.
2. Dispenser Models
Remove crushed/cubed ice switch cover on dispenser
by pulling forward. Remove screws from bottom of
dispenser cover. Release bottom clips on dispenser
cover by placing taped edge of putty knife underneath
cover and pulling out. Release top clips by holding
bottom of dispenser cover out and sliding up.
Description Qty PK201E
(Black)
PK201W
(White)
PKD201E
(Black)
PKD201W
(White)
Refrigerator door panel 1 10096944 10096940 10096944 10096940
Freezer door panel 1 10096943 10096939
Freezer door upper panel 1 10096949 10096945
Freezer door lower panel 1 10096986 10096983
Refrigerator door spacer 1 10234611 10234611 10234611 10234613
Freezer door spacer 1 10234612 10234612
Freezer door upper spacer 1 10234609 10234609
Freezer door lower spacer 1 10234625 10234625
Installation instructions 1 10599708 10599708 10599708 10599708
Parts List
PK201 and PKD201 1/4" Decorator Door Panel Kits
To Next Page
Loading...
