RS5290000 Rev. 0 98 April 1998
Kit Instructions
3. Remove door handle inserts by placing screwdriver
at top of door handles in area between handle and
insert and pulling out.
4. Pull edge of inserts forward along length of handles.
Caution
To avoid personal injury or property damage, hold
handles when removing.
5. Remove door handles by removing screws. Bottom
inserts are removed with handle.
6. Remove top door trim by removing screws.
7. If refrigerator has decorator panels, carefully slide
panels out. On dispenser models, remove
dispenser trim.
8. Remove trim on sides of doors by placing taped
edge of putty knife underneath trim and pulling out.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
9. Tape doors shut using masking tape.
10. Remove top hinge covers by removing screws.
Trace around top hinges with a pencil. This helps
alignment when reassembling. On dispenser
models, unplug top hinge wire connectors. Remove
top hinge screws.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, green ground wire must
remain attached to hinge.
11. Remove tape from refrigerator door. Grasp
refrigerator door securely and lift up while opening.
This will free door from bottom hinge pin. Top hinge
may come off door.
12. Remove toe grille by pulling forward.
To Next Page
Loading...
