April 1998 99 RS5290000 Rev. 0
Kit Instructions
Caution
To avoid property damage, drain water from water tube
into small bucket.
13. Dispenser Models
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Gently pull water tube away
from union nut and through tube clamp.
14. Remove tape from freezer door. Grasp freezer door
securely and lift up while opening. This will free
door from bottom hinge pin. On dispenser models,
plastic water tube must slide through slot in bottom
door hinge as door is raised. Top hinge will remain
attached to door.
15. Remove bottom door trim by removing screws.
When installing HTK200S, HTGK200W, HTK220S
and HTK220W kits, remove door stops. Confirm
support plate is under door trim. Install new bottom
door trim by placing trim on bottom of doors. Insert
and tighten screws. When installing HTK200S,
HTGK200W, HTK220S and HTK220W kits, install
new door stops by placing door stops on bottom of
doors. Insert and tighten screws.
16. Rehang doors by positioning bottom sockets onto
bottom door hinge pins. Position so doors are flush
with sides of refrigerator cabinet. Handle side of
doors should be approximately 1/8 inch (3.2
millimeters) higher than hinge side of doors. Doors
will settle when loaded with food. On dispenser
models, when replacing freezer door, thread water
tube through bottom hinge pin and water tube
clamp.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
17. Tape doors shut using masking tape.
Important
• Ensure trim pieces adhere properly by confirming
surfaces are clean, dry and free of adhesive
residue.
• Discard factory installed trim and handles.
18. Replace top hinges by placing top hinges on
refrigerator. Insert and tighten screws. On
dispenser models, reconnect top hinge wire
connectors. Install new top hinge covers by placing
hinge covers over hinges. On dispenser models,
carefully place wires under cover to avoid pinching
wires. Insert screws and tighten.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, green ground wire must be
attached to freezer door hinge.
19. Install new bottom door handle caps by pushing up
into bottom of new handles until caps snap in place.
20. Install new door handles by placing door handles on
door. Insert and tighten screws. Install new handle
inserts by snapping in place.
To Next Page
Loading...
