Installation & Operation Guide Page 41 of 48
Send Maps: Press the button to send user(s) biometric map(s) from Time Guardian to the selected terminals. Only
employees assigned to terminals will be sent. Employees are assigned to terminals from the terminal validation. Because the
“Send Maps” operation consists of first clearing all templates from the terminal and then loading assigned employee templates.
(Please be careful with sending maps)
Receive Maps: Press the button to receive employee templates from the selected terminal(s) to Time Guardian
database. Only templates assigned to the selected terminals will be uploaded to TG. This is recommended to be done
periodically for backing up enrollments.
Clear Maps: Press the button to clear (delete) all assigned employee templates from the terminal. Because the Clear
Maps operation consists of clearing all templates from the terminal, a confirmation dialog box will appear before this command
executes.
Caution! This command can be used to clear [reset] the terminal if an Administrator has been setup and the password is
lost, etc. Access at the terminal to the menu options, etc. maybe denied unless it is an Administrator. Call Amano support for
assistance.
Note: All the above command options can be performed at either the MTX-30 or FPT. Whereas, the "Polling" and “Set time”,
"Downloading" commands from the Communication menu can only be performed on all models.
To Next Page
Loading...
