4
EN
WARNING
Risk of electric shock! Use
special care when making measurements, if the
voltages are greater than 25V~ RMS or 35V .
These voltages are considered a shock hazard.
CAUTION
Risk of injury! The probe tips are
sharp for accuracy. Be careful when handling and
reattach the probe tip shrouds after use.
• This product is intended for measurements
on electrical installations and is protected
by double insulation as per EN61010-1 and
IEC61010-1, 2nd Edition (2001) to Category IV
600V and Category III 1000V; Pollution Degree
2. The product also meets requirements of
UL 61010-1, 2nd Edition (2004); CAN/CSA
C22.2 No. 61010-1, 2nd Edition (2004); and
UL61010B-2-031, 1st Edition (2003).
• This product must be used by trained users
only.
• Do not exceed the maximum allowable input
range of any measurement mode.
To Next Page
Loading...
