Amazon Fire Phone - Inserting the SIM Card

Getting Started
9
Insert a SIM Card
The SIM card tray for Fire phone is located on the left side of your device below the Camera / Firefly
button.
Before you can use your Fire phone to make or receive calls, you'll need to insert a nano SIM card into
your phone. If you phone doesn't have a SIM card installed, you'll see the message "No SIM" in the Status
Bar at the top of the screen.
Note: If you purchased your Fire phone with service through AT&T, the nano SIM card is already
installed on your device.
To insert a SIM card:
1. Insert the SIM unlock tool (or a paperclip) into the hole in the SIM tray and apply gentle pressure
until the tray pops out.
2. Place the SIM card into the tray. Make sure the metal contacts are facing down and the slanted edge
of the SIM card matches the tray.
3. Slide the SIM tray into the phone. The "No SIM" message will disappear and the wireless signal
indicator in the Status Bar will indicate that you're now connected to a mobile network.
4. If you don't see the wireless signal indicator, press and hold the Power button, and then tap Restart
to restart your device.
Note: If you're unable to activate your phone, or you need a nano SIM card, contact your mobile
service provider for assistance.