EN
10
9.1.3 Cleaning the foam lter
1. Press the dust container release button (G) to detach the
dust container (E) from the main unit (D) (Fig. 9).
2. Remove the foam lter (H) from the dust container (E)
(Fig. 13).
13
H
E
3. Submerge the foam lter (H) in water. Add a few drops of
mild detergent if needed.
4. Squeeze it to allow the dirt to escape and rinse it with clean
water.
5. Allow it to air dry for 24 hours before retting it to the dust
container (E).
NOTICE
» Replace the foam lter (H) every 3 months or when it is
heavily soiled. Replace only with the identical lter model
(B0C2YN3YH4).
» The replacement foam lter (model: B0C2YN3YH4) can be
purchased from Amazon website.
*The terminology used on Amazon website may dier based
on the languages used in the region.
9.1.4 Cleaning the HEPA lter
1. Unlock the top cover of the main unit (D) by turning it
counter-clockwise, and then take the HEPA lter (I) out
(Fig. 14).
14
I
1
2
D
2. Tap the HEPA lter (I) gently to remove any excess dust and
debris.
3. Rinse the HEPA lter (I) with cold water.
NOTICE To maintain the eciency of the HEPA lter (I),
do not rub, squeeze, or scrub it to avoid damaging the delicate
bers.
4. Allow it to air dry for 24 hours before retting it to the main
unit (D).
9.1.5 Cleaning the motorized brush
NOTICE Regularly check the brush roll of the motorized
brush (N) for stubborn soiling such as trapped hair and thread.
Clean the inside of the motorized brush (N) when needed.
1. Remove the locking guard from the motorized brush (N) by
pressing the locking tab down (Fig. 15).
15
2. Take the brush roll out (Fig. 16) and remove any threads, hair
or debris tangled around the bristles with a brush.
16
3. Ret the brush roll and the locking guard properly
afterwards.
9.2 Storage
» When storing the appliance for extended period, charge it
once every 3 months.
» Store the appliance ideally in the original packaging, in a dry
and dust-free area.
» Avoid areas with high humidity or extreme temperatures.
» Keep away from children and pets.
9.3 Maintenance
Any other servicing than mentioned in this manual should be
performed by a professional repair center.