To Next PageTo Next Page
Need help?Do you have a question about the Amba RADIANT RWHL-CP and is the answer not in the manual?
Covers essential safety precautions, electrical requirements, and potential hazards during installation and use.
Details on how to turn the unit on, heating time, and recommendations for continuous use.
Lists all parts provided for installation and specifies the necessary tools for setup.
Explains the integrated on/off switch, its location, and illumination indicators.
Details the 2-year limited warranty terms, conditions, and requirements for validity.
Lists technical specifications like voltage, frequency, power input, and safety certifications.
Provides essential contact details including phone, fax, email, and website for customer assistance.
The Amba Radiant Large Curved Hardwired Heated Towel Rack is designed to warm and dry towels, enhancing comfort and hygiene in your bathroom. This device is intended for indoor use only and should not be placed inside a shower, sauna, steam room, or any location where it would be exposed to water. It is crucial to adhere to all installation instructions and safety warnings to ensure proper operation and longevity of the unit.
The primary function of the Amba Radiant Large Curved Hardwired Heated Towel Rack is to gently heat and dry towels. By providing warmth, it helps to eliminate dampness and prevent the growth of mildew and unpleasant odors, ensuring that you always have a fresh, warm towel ready after a bath or shower. The radiant heating technology ensures even heat distribution across the bars, optimizing the drying process for multiple towels. This unit is designed to operate continuously, providing consistent warmth, but can be turned off via its integrated switch when not in use for extended periods.
The Amba Radiant collection features an integrated on/off switch, conveniently located at the bottom of the left vertical bar. To operate the unit, simply remove the protective plastic cover from the switch and press it to the "on" position. A red indicator light will illuminate, signifying that the towel warmer has begun to heat. The unit typically takes 10-20 minutes to reach its optimal heating temperature.
The design of the towel rack, with its curved bars, allows for easy placement and retrieval of towels, accommodating various towel sizes and maximizing surface contact for efficient drying. The hardwired installation provides a clean, seamless look, integrating the unit directly into your bathroom's electrical system without visible cords.
It is important to note that while the unit is designed for heating, the surface temperature can increase depending on the ambient room temperature and the number of towels placed on it. Overloading the unit can cause it to become extremely hot, potentially leading to burns if touched or damage to the towels. Therefore, users should exercise caution and avoid placing an excessive number of towels on the rack. The unit is specifically designed for drying towels and should not be used for climbing or hanging on.
The Amba Radiant Large Curved Hardwired Heated Towel Rack requires minimal maintenance. As a hardwired unit, it is permanently connected to the electrical system, eliminating the need for frequent checks of plug connections. The durable construction and quality materials ensure long-term performance.
For cleaning, it is recommended to use a soft, damp cloth to wipe down the surfaces. Avoid using abrasive cleaners or harsh chemicals, as these can damage the finish of the towel rack. Ensure the unit is turned off and cool before cleaning.
The installation process is straightforward, but it must be performed by a certified electrician in accordance with the National Electrical Code (NEC) and the Canadian Electrical Code (CEC). The unit requires a 120-volt, 60 Hz power source and must be installed on a GFCI (Ground Fault Circuit Interrupter) protected circuit for safety. The installation kit includes fasteners, but it is the installer's responsibility to ensure that appropriate mounting hardware is used for the specific wall type to securely fix the unit. Proper installation is crucial for the safe and effective operation of the towel warmer.
The device is available in two finishes: polished (RWHL-CP) and brushed (RWHL-CB), allowing users to choose the option that best complements their bathroom decor. The integrated switch design contributes to the unit's sleek aesthetic and ease of use.
Regular adherence to the operating instructions and warnings will help maintain the unit's performance and extend its lifespan. The two-year limited warranty covers defects in workmanship and materials, provided all terms and conditions of sale are met and installation instructions are followed. For full warranty details and terms of sale, users can visit the manufacturer's website.
General| Manufacturer | Amba |
|---|---|
| Model | RADIANT RWHL-CP |
| Category | Food Warmer |
| Power Supply | Electric |
| Material | Stainless Steel |
| Temperature Control | Adjustable Thermostat |
