Page 30 of 38
Quick Start Procedure
Hydronic Heat Pump Units
✓ Press the TARGET TEMP button
The Settings screen will now be displayed
✓ Press Enter button and the curser will now be flashing
on
Mode: OFF
✓ Press the UP or DOWN arrows to select HEAT ONLY,
COOL ONLY or OFF
✓ Press ENTER when desired mode is flashing
✓ Set Heating Water Target Temperature using the UP or
DOWN arrows then press ENTER
✓ Set Cooling Water Target Temperature using UP or
DOWN arrows and then press ENTER
✓ Press RETURN button to the MAIN SCREEN
Heat pump unit should now start to run on selected
mode
✓ Keep an eye on the System Supply and Return Water
Temperatures
✓ Check system pumping flow rates and proceed to
bleed air from all air bleed points on the hydronic
system (Example. Radiators, manifolds, pumps, tanks
and high points)
✓ Run and check system operation
✓ Full System Operation Real Time Date can be viewed
by pressing the DOWN arrow button from the MAIN
SCREEN – Keep pressing the DOWN arrow to view all the
heat pump operation screens
To Next Page