Ambirad SmartCom2 - User Manual

SmartCom
2
Installation and User Manual
for Lite, Standard, Advanced and Network versions
Quick Guide
SETTINGS
12
6
39
SETTINGS
12
6
39
SET
CLOCK
SETTINGS
12
6
39
SET
AUTO
MODE
SETTINGS
12
6
39
SETTINGS
12
6
39
SET
FROST ONLY
MODE
SET
HEAT ONLY
MODE
SET
VENT
ONLY
MODE
SETTINGS
12
6
39
SET
PROGRAM
TIMES
SETTINGS
12
6
39
SET
TEMPERATURES
Initialise Programming
Press repeatedly to
access required setting
SETTINGS
12
6
39
Press to return
to main display
UNDO
The SmartCom
2
control is factory set to operate on warm air systems. To change
settings for radiant products please refer to Section 4, Engineer Functions.
PLUS
Increase a value
VENT ONLY
Initiate a period of forced
vent operation
MINUS
Decrease a value
OVERTIME
Initiate or quickly extend a
period of heating
OK
Accept a newly entered value
HOLIDAY
Set the control to holiday
mode
UNDO
Press once to cancel overtime, vent,
exam, off and holiday modes or a
newly entered value not yet OK’d
CHECK TEMP
Toggle the display to show
the temperatures
SETTINGS
12
6
39
Change the settings (see diagram
below)
LOCKOUT
Clear a fl ame failure lockout
SETTINGS
12
6
39
SET
OFF
SET
EXAM
MODE
Optional

Ambirad SmartCom2 Specifications

General

Type	Remote Control
Compatibility	Ambirad heaters
Frequency	433 MHz
Features	programmable
Battery Type	2 x AA

Summary

Technical Specifications

Installation Instructions

Mounting the Control Assembly

Instructions for physically mounting the control unit housing.

General Wiring Specifications

General guidelines and safety precautions for wiring connections.

Lite Version Wiring Connections

Specific terminal connections for the Lite version of the control.

Standard Version Wiring Connections

Specific terminal connections for the Standard version of the control.

Advanced Version Wiring Connections

Network Version Wiring Connections

Operating Instructions

Setting the Clock

Setting the Operating Modes

How to select and set different operational modes (Auto, Frost, etc.).

Setting the program (on;off times)

Instructions for programming daily on/off times and temperatures.

Setting the Day & Night Temperatures

Error Message:- Lockout

Explains the lockout error and how to reset it.

Engineer Functions

General Password (PIN Protection)

How to set or bypass the engineer function PIN code.

Programming The Engineer Functions

Guide to accessing and programming advanced engineer settings.

The Engineer Variables

Explanation of various configurable parameters for engineer functions.

External Inputs