GB
7
Programming the 24 hour clock.
A 4 digit LED display will constantly indicate the real time.
The real time setting procedure:
Press the “SET” button for 2 seconds. The 2 digits on the left of the display [10] will
blink indicating it is now possible to change the hours setting on the clock.
Repeatedly press the “UP” or “DOWN” button until the correct hour is shown.
Press the SET” button for the second time until the 2 right digits in the 4 digit
display [10] blink indicating it is now possible to change the minutes setting on the
clock.
Repeatedly press the “UP” or “DOWN” button until the correct minute(s) is
shown.
Press the “SET” button for the third time.
The current time is set, the 4 digit display indicates the time constantly until the
Time button [11] is pressed to program the timer.
Programming the Timer – when the machine is OFF
Please familiarise yourself with this sequence before setting the timer. Long delays
in the sequence of setting will cause the timer to revert back to the 24 hour clock
display. This will then involve starting the sequence again from the beginning.
Press the “TIMER” button when the unit is off.
The 2 digits to the left of the 4 digit display – the hours - will blink indicating it is
possible to change the hours setting on the timer. Additionally the word ON will be
shown alongside the digits.
Repeatedly press the “UP” or “DOWN” button until the desired hour is shown on
the timer.
Press the “TIMER” button again.
The 2 digits to the right of the 4 digit display – the minutes - will blink indicating it
is possible to change the minutes setting on the timer. Additionally the word ON
will be shown alongside the digits.
Repeatedly press the “UP” or “DOWN” button until the desired minutes are shown
on the timer.
AT THIS POINT YOU HAVE TWO OPTIONS EITHER
1. Press “SET” and the unit will switch on at the desired time and remain ON.
It will switch on at the setting that was last used. The Timer Light will illuminate.
To Next Page
Loading...
