EasyManua.ls Logo

Amcor HD 2000HT - Page 6

Amcor HD 2000HT
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
6
ON/OFF button
Switches the unit on or off, while the compressor is running, the POWER light [1] is
on.
Fan SPEED Control
The Amcor dehumidifier features a two-speed fan control. Press the button marked
“SPEED” to illuminate the high fan speed indicator [3] for fast operation. For qui-
eter operation press the” SPEED” button to illuminate the low indicator [4].
Relative Humidity Setting
By depressing button “UP or DOWN” repeatedly you can choose from a range of
relative humidity settings:
CONT [6] _ 50% [5] _ 60% [5] _ 70% [5] _ 80% [5]
Generally we feel most comfortable when the setting is 50%-60%. Select your pre-
ferred humidity level and the unit will run until the moisture in the room reaches
the desired level. From then on it will cycle on and off to maintain the level chosen.
If “CONT.” is selected [6], the dehumidifier will run continuously irrespective of
how dry the air becomes.
The digital display indicates the actual relative humidity level in the air. In most
cases you will see a reduction in condensation within a few days. In severe cases,
however, it may take several weeks to remove sufficient moisture to obtain an ac-
ceptable humidity level.
HEAT button
The 800W fan heater, activated by depressing the HEAT button, only runs with high
fan speed. The HEAT indicator [8] will come on when the heater is operating.
To activate the heater without dehumidification select 80% RH as explained above
and then press the heat button. The compressor will stop (power light 1 will go off)
and the heater only will run with high speed fan.
The heater should not be used in room temperatures above 21˚C. Above 25 ˚C the
heater will automatically cut off.
The unit will discharge warm dry air from the top grill making it effective in drying
damp items e.g. clothes in the area.
To avoid possible heat damage to fabric leave at least 1 m gap around the unit.
Garments must not be dried on top of this unit; this will restrict the air flow, cause
damage to the unit/ fabric and present a risk of fire / electrical shock.

Related product manuals