PROGRAMMING
12
Enter The New Code
The display will show:
Enter any three key combination of the following buttons: .
Next, the controller will display for a second the message shown in the figure below and then switch to the three
dashes display.
The display will show:
The display will show:
Re-enter the new code.
After successfully re-entering the new code, the controller will briefly display the message shown in the figure
below.
The display will show:
If you wish to skip parameter programming press until you get to the OFF message.
To change the controller parameters, see the “Parameter Programming” section of this manual.
Make a note of the new code.
To Next Page
Loading...
