American Panel Walk-in Monitoring System 100 User Manual

REV. C
Cooler is Better!
TM
Owner’s Manual
Walk-in Monitoring
System 100
(BATT)
Used in UL Listed Door Panel Assemblies
American Panel Corporation
5800 S.E. 78th Street, Ocala, Florida 34472-3412
Phone: (352) 245-7055 Fax: (352) 245-0726
E-mail: service@americanpanel.com

American Panel Walk-in Monitoring System 100 Specifications

General

Brand	American Panel
Model	Walk-in Monitoring System 100
Category	Measuring Instruments
Language	English

Summary

Parameter Programming

Enter The Access Code

Instructions for entering the default or custom access code to enable programming mode.

Real Time Clock Settings

Door Frame Heater Settings

Alarm Settings - High Air Alarm

Alarm Settings - Low Air Alarm

Alarm Settings - Time Delay

Light Off Delay

Air Temperature Probe Offset

Calculating the Probe Temperature Offset

Method for determining the temperature difference to correct probe readings.

Adjust the Probe Temperature Offset

Steps to input the calculated offset to fine-tune the air temperature reading.

Change the Access Code

Restore the Default Settings

Operating WIMS 100

Turn On the Controller

Read the Walk-in Air Temperature and the Current Time

Read the Door Frame Heater Temperature

Operate the Light Switch

Error Messages