American Panel Walk-in Monitoring System 100 - Real Time Clock Settings; Door Frame Heater Settings

PROGRAMMING
5
The display will show:
Press .
Real Time Clock Settings
The display will show:
Press or .to set the flashing value to “1” (Enabled) if you wish to enable the real time clock. If
real time clock is enabled, the time will be displayed during normal operation.
Press when done.
The display will show:
Press or .to change the flashing value to current time in one minute increments.
Press and hold or to change the current time in thirty minute increments.
Press when done.
Door Frame Heater Settings
The display will show:
This function will turn the door frame heater on or off.
By default, the door frame heater is set to on (“1”). If you wish to turn the door frame heater off, change the
flashing value from “1” to “0” (off) by pressing or .
Press when done.
Note: If you set the flashing value to “0”, door frame heater off, the controller will skip to alarm settings. In
case the flashing value is set to “1”, door frame heater on, the controller will guide you thru door frame heater
settings