RECOMMENDED TOOLS AND MATERIALS
Putty Knife Regular Screwdriver Adjustable Wrench Sealant Tape Measure
Hacksaw Wax Ring/Gasket Flexible Supply Tube Closet Bolts Carpenters Level
1 REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
SAVE FOR FUTURE USE
7302485-100 10/20
2 3 4
CLOSET FLANGE
CLOSET
BOLTS
WAX
RING
A
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2020
NOTE: Pictures may not exactly define contour of china and components.
INSTALL WAX SEAL
Invert toilet on floor (cushion to
prevent damage), and install wax
ring evenly around waste flange
(horn), with tapered end of ring
facing toilet. Apply a thin bead of
sealant around toilet base.
POSITION TOILET ON FLANGE
a.
Unplug floor waste opening and install toilet on
closet flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked "THIS SIDE UP" must face up!
CLOSET
BOLT
NUT
TAPERED
WASHER
FLANGE
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
!
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Reliant
®
Two-Piece Toilet
250AA104.020 - Chair Height Elongated
Bowl: 3437A101.020
Tank: 4425A104.020
250CA104.020 - Standard Height Elongated
Bowl: 3437C101.020
Tank: 4425A104.020
250DA104.020 - Standard Height Round Front
Bowl: 3437D101.020
Tank: 4425A104.020
INSTALL CLOSET BOLTS
Install closet bolts in flange channel
and slide into place parallel to wall.
Press Firmly
PLASTIC
CONE
MUST FACE
AWAY
FROM BOWL
.
.
A3
Apply weight evenly.
Do not move after placement.
Water tight seal may break.
To Next Page
Need help?
General
