EasyManua.ls Logo

American Standard Standard Residential User Manual

American Standard Standard Residential
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Operating, installation
and service manual
Standard Residential power vent
Gas Water Heater with vaporshield Technology.
WARNING: If the information in these instructions is not followed exactly, a re or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other ammable vapors and liquids in the vicinity of this
or any other appliance.
WHAT TO DO IF YOU SMELL GAS
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use any
phone in your building.
3. Immediately call your gas supplier from a neighbor´s phone.
Follow the gas supplier´s instructions.
4. If you can not reach your gas supplier, call the re department.
Installation and service must be performed by a qualifed installer, service agency or the
gas supplier.
THIS WATER HEATER SHALL NOT BE INSTALLED IN BATHROOMS, BED-
ROOMS, OR ANY OCCUPIED ROOM NORMALLY KEPT CLOSED.
VAPORSHIELD® Technology Gas Water Heatersmeet the new ANSI Z21.10.1
standard that deals with the accidental or unintended ignition of ammable vapors,
such as those emitted by gasoline.
WARNING: This water heater is equipped for one type of gas only. Check
the data plate near the gas control valve for the correct gas. DO NOT USE THIS
WATER HEATER WITH ANY GAS OTHER THAN THE ONE LISTED ON THE
DATA PLATE. Failure to use the correct gas can cause problems which can result
in DEATH, SERIOUS BODILY INJURY OR PROPERTY DAMAGE. If you have any
questions or doubts consult your gas supplier or gas company. Water heaters for
bottled, propane or liqueed petroleum gas (LPG) are different from natural gas
models. A natural gas heater will not function safely on bottled, propane or lique-
ed petrolum gas (LPG) and no attempt should be made to convert a heater from
natural gas to any other gas.
INSTALLER:
1. Afx these instructions or adjacent to water heater.
2. Before leaving premises: REVIEW this operation,
installation and service manual to be sure heater has been installed correctly.
Make sure unit is started and operated for one complete cycle and water
temperature is acceptable to he costumer at the xtures.
OWNER:
1. Retain these instructions and warranty for future
reference.
All technical and warranty questions should be directed to the local dealer from
whom the water heater was purchased. If you are unsuccessful please write to
the company listed on the warranty or data plate which came with your water
heater.
CALL THIS TOLL FREE NUMBER 1-888-883-0788
WITH ANY QUESTIONS DURING OR AFTER INSTALLATION.
HAVE YOUR MODEL AND SERIAL NUMBER AVAILABLE BEFORE
CALLING.
1120287 - REV. AUG 19
Question and Answer IconNeed help?

Do you have a question about the American Standard Standard Residential and is the answer not in the manual?

American Standard Standard Residential Specifications

General IconGeneral
BrandAmerican Standard
ModelStandard Residential
CategoryWater Heater
LanguageEnglish

Summary

GENERAL SAFETY

CONSUMER RESPONSIBILITIES

Unpacking the Water Heater

Instructions for safely removing the water heater from its packaging.

Location

Guidelines for selecting an appropriate and safe installation site.

TYPICAL INSTALLATION

AIR SUPPLY

ALL AIR FROM OUTDOORS

Specifies requirements for air intake directly from the outdoors.

ALL AIR FROM INSIDE THE BUILDING

Details requirements for air intake from within the building.

VENTING

DISCHARGE OF PURGED GASES

Precautions for safely discharging purged gases from piping.

MECHANICAL EXHAUSTING AND FIREPLACES

How other exhaust systems may affect water heater operation.

POTENTIAL HAZARDOUS DOWNDRAFT OPERATION

Warnings about downdraft conditions affecting appliance safety.

TEMPERATURE & PRESSURE RELIEF VALVE

THE DISCHARGE LINE

Guidelines for the discharge line of the relief valve to ensure safe operation.

SPACE HEATING/POTABLE WATER SYSTEM

BLOWER ASSEMBLY INSTALLATION

INSTALLATION OF VENT SYSTEM

PLANNING THE VENT SYSTEM

Steps for planning the layout and components of the vent system.

VENT PIPE PREPARATION

SELECTION OF MATERIALS (PCV and CPVC VENTING)

Guidance on choosing appropriate materials for PVC and CPVC venting.

OPERATING INSTRUCTIONS

INSTALLATION CHECKLIST

GAS REQUIREMENTS

TROUBLESHOOTING CHECK LIST

READING THE LED FLASH SEQUENCE

REPAIR PARTS ILLUSTRATION

IF YOU NEED SERVICE

Related product manuals